>> P.506
■Types■Precautions for UseSuper Flexible Nozzles shown in Table 1 are avail-When the press tting type Super Flexible Nozzle is able.Table 1 Type of Super Flexible NozzleTypeModel codePress fitting typeScrew fitting typeWithout nozzleWith nozzleWith metric threadsWith taper pipe threadsSNASNM SNPTused, a φ15 (H8) bore for tting hole must be +0.0270prepared and tting is made from the 30°chamfered end of the outer body. In this case, the body portion should be pushed for press tting.When the screw tting type Super Flexible Nozzle is used and prevention of oil leakage from the tting part is required, it is recommended to wind sealing tape on the thread portion or use rubber packing for the shoul-der face of the outer body.The direction of lubrication can be adjusted by insert-ing a screwdriver, etc. in the bore of the nozzle.■Identification Number■Special SpecificationsThe identification number of Super Flexible Nozzle Super Flexible Nozzles with special length are also consists of a model code and a size. An example is available. In this case, specify the necessary nozzle length in units of 1 mm, but do not exceed the maxi-mum length shown in the dimension table as "L". Super Flexible Nozzles with curved nozzle end or with special bore diameter are also available. In this case, please contact IKO by preparing a drawing or sketch with necessary specications. shown as follows.Example of identication numberModel codeSizeSNM10-20Type of nozzleNozzle bore or thread size: (M10×1.25)Dimension from shoulder surface to nozzle top:※(20mm)※In case of press fitting type without nozzle, this dimension is not indicated.K57
| < 
| 
> | 
>>
